This unique precision-machined fixture is used on your surface grinder for accurately holding and positioning pins and ejector pins for quick and easy cutoff and grinding.
The 1-1/4" wide linear pin grip holds 1/16" to 3/4" diameter pins firmly. Pressure is spread out over the entire width of the grip, eliminating grinding chatter and dents in pins that normally occurs when using a single-point V-block.
Pins 14" and longer are easily and accurately ground to length. Can be used in horizontal position for end grinding or attached to angle iron for vertical use and face grinding.
Measures 4-1/2"W x 3"D x 3-1/2"H.