Marathon FMR Mini-Filer Micromotor System with 1.0mm HP

Combining the FMR Mini-Filer with our new Power Hand M-08X micromotor (1,000- 8,000rpm) gives improved control and flexibility for filing, deburring and polishing. This system is available two ways: Mini Filer with 0.5mm stroke length, M-08X micromotor, Marathon Controller and 3 Ceramic Stones. Mini Filer with 1.0mm stroke length, M-08X micromotor, Marathon Controller and 3 Ceramic Stones. Marathon Controller features an overload protection cut-off switch, forward/reverse switch, voltage selection (110/220V), and produces 0-30V DC (continuously variable). Accepts our full range of Power Hand 3 and standard micromotor handpieces. An optional variable speed foot rheostat TPF-77 is sold separately (listed in drop-down menu below). Measures 4-1/2" wide x 5-1/4" deep x 3-3/4" high. Weighs 5.5 lbs. 110/220V, 50/60Hz. Three NSS Ceramic Stones (Round, 3mm x 50mm) in 800, 1000 and 1200 grits are included. Safety Recommendations For FPS and FPC Di-Profilers, FMR Mini Filers and Micromotor Drive Di-Profilers Prolonged use of vibrating or reciprocating tools may result in vibration-induced circulation problems in the hands. Always follow safe operating procedures. Using hand protection (i.e., insulated gloves) and taking frequent breaks can help minimize but not guarantee against injury. Operating these types of tools in cold weather or with a tight grip will reduce the period of operation before risking potential injury. Individuals with a tendency to suffer from poor circulation, frequently cold fingers or itchy hands should closely monitor the condition of their hands. If symptoms appear, seek medical advice immediately.